Source water refers to surface water (e.g. lake) or groundwater (e.g. aquifer) sources that are used for drinking water. Therefore, source water protection refers to the protection of surface water and groundwater drinking water sources from both contamination and overuse.
Within the Kettle Creek watershed there are two sources of municipal drinking water: the Elgin Area Primary Water Supply System (EAPWSS) and the Belmont Water Supply System (BWSS). The EAPWSS, located east of Port Stanley, has a treatment capacity of 91 million litres of water per day and serves a population of approximately 112,000 individuals in the cities of London and St. Thomas, the municipalities of Bayham, Central Elgin, and Dutton Dunwich, the townships of Malahide and Southwold, and the town of Aylmer. The BWSS operates two artesian wells that supply 500 cubic metres of water per day to 1,900 individuals within the village of Belmont.
In 2000, Walkerton Ontario’s water supply became contaminated with E. coli from agricultural runoff, which caused the death of seven individuals, while another 2,300 individuals became ill. In response, a multi-barrier approach was recommended to protect municipal drinking water throughout Ontario. As part of that process, the Kettle Creek Source Protection Plan was developed and approved on September 11, 2014, and took effect on January 1, 2015.
The Kettle Creek Source Protection Plan establishes policies to effectively address significant drinking water threats now and in the future for both the EAPWSS and the BWSS. While the BWSS has no significant drinking water threats, the handling and storage of commercial fertilizer (greater than 5,000 cubic metres) and fuel (greater than 6000 litres) are significant risks to the EAPWSS. Therefore, Risk Management Plans have been developed and implemented to ensure these existing activities cease to be significant drinking water threats. Future handling and storage of commercial fertilizer and fuel in large quantities are prohibited according to the policies established by the Kettle Creek Source Protection Plan.
An Intake Protection Zone (IPZ) surrounds the EAPWSS intake pipe, which is defined as the area, both land and water, surrounding an intake pipe that is vulnerable to potential contaminants that may pose a significant threat to the drinking water source. Under the Clean Water Act, 2006, several IPZs have been identified: one that is proximity based (IPZ-1), one that is time based (IPZ-2), and one that is event based (IPZ-3). IPZ-1 represents a 1 kilometre radius around the intake pipe, which as a result of proximity is the most vulnerable to contaminants. IPZ-2 represents a 2-hour time of travel to the intake pipe. This means that it would take 2-hours for a contaminant to reach the intake pipe from anywhere within IPZ-2. IPZ-3 is event based, and represents the area where a spill of commercial fertilizer from harbour lands or a spill of diesel fuel from the EAPWSS could deteriorate the water quality at the intake pipe.
A Wellhead Protection Area (WHPA) surrounds the BWSS wells, which is defined as the area, both above and below ground, surrounding a wellhead that is vulnerable to potential contaminants that may pose a significant threat to the drinking water source. Under the Clean Water Act, 2006, several WHPAs have been identified: one that is proximity based (WHPA-A) and three that are time based (WHPA-B, WHPA-C, and WHPA-D). WHPA-A represents a 100 metre radius around the wellheads, which as a result of proximity is the most vulnerable to contaminants. WHPA-B, WHPA-C, and WHPA-D represent a 2-year time of travel, 5-year time of travel, and 25-year time of travel, respectively. This means that it would take 2-years, 5-years, and 25-years for a contaminant to reach the wellhead from anywhere within their respected WHPA.
To learn more, please see the Lake Erie Source Protection Region’s website at www.sourcewater.ca and/or consult the following resources.
Kettle Creek Source Protection Area: Source Protection Primer Kettle Creek Source Protection Area: Part-IV Primer Source Water Protection: Where Does Your Drinking Water Come From? Source Water Protection: Port Stanley Intake Protection Zone Source Water Protection: Belmont Wellhead Protection Area Source Water Protection: Dense Non-Aqueous Phase LiquidsDisclaimer: This map is for information purposes only. Kettle Creek Conservation Authority take no responsibility for, nor guarantees, the accuracy of all the information contained within the map.
Search
News Archives
- January 2021
- December 2020
- November 2020
- October 2020
- September 2020
- August 2020
- July 2020
- June 2020
- May 2020
- April 2020
- March 2020
- February 2020
- January 2020
- December 2019
- November 2019
- October 2019
- September 2019
- August 2019
- July 2019
- June 2019
- May 2019
- April 2019
- March 2019
- February 2019
- January 2019
- December 2018
- November 2018
- October 2018
- September 2018
- July 2018
- June 2018
- May 2018
- April 2018
- February 2018
- January 2018
- December 2017
- November 2017
- October 2017
- September 2017
- July 2017
- June 2017
- May 2017
- March 2017
- February 2017
- January 2017
- December 2016
- October 2016
- September 2016
- July 2016
- June 2016
- April 2016
- March 2016
- February 2016
- January 2016
- December 2015
- November 2015
- October 2015
- July 2015
- June 2015
- March 2015
- February 2015